Linked Questions

0
votes
2answers
270 views

Can someone explain film speeds to me? [duplicate]

I know the whole 200 400 800 is based on the speed of the film & say youre in a dark room with dim lighting, 800 would be a better choice to use.. But i have searched through flickr and i see most ...
1
vote
0answers
210 views

What is happening in the sensor when you change the ISO? [duplicate]

I understand the relationship between ISO, aperture and shutter speed. What I'd like to know is what actually happens in the sensor when you raise or lower the ISO number? In other words, what is ...
0
votes
1answer
78 views

Is the following video explaining ISO accurate? [duplicate]

So, I was searching for the exact mechanism behind the workings of ISO (or film speed) in digital camera. I found this video and it was pretty simple. But i was wondering if this video is accurate and ...
71
votes
7answers
20k views

How is ISO implemented in digital cameras?

If I change the ISO settings on my camera, obviously the gain of the system is increased, amplifying the signal from the sensor. What's not clear to me is where the amplification takes place. I see ...
41
votes
7answers
80k views

Is it better to shoot with a higher ISO, or use lower ISO and raise the exposure in post-processing?

Suppose there are two photos taken in the following scenario: Scenario 1 - Photo taken using ISO of 3200. Scenario 2 - Photo taken using ISO of 100. Both photos are taken in a medium light scenario....
29
votes
8answers
5k views

Is high ISO useful for photography?

I started photography sometime back, and always wondered when is high ISO handy in photography? Also can it be used to get any special effect in pictures? My camera has Max ISO of 800 but I see some ...
16
votes
3answers
3k views

If I want to shoot darker shots, is it better to increase the lighting and then darken in post to retain clarity?

I'm just getting started - in my last shoot, I was using a 6D with a 50mm/1.4. In low light, the pictures looked fantastic on the viewfinder but on the computer screen, appeared extremely grainy. ...
10
votes
6answers
5k views

Why would using higher ISO and faster shutter speed yield more noise than using lower ISO and slower shutter speed?

I'm trying to see how this answer correlates with practice. That answer basically says I need to let enough light into the camera and then use the highest ISO value and I'll get the lowest noise then. ...
23
votes
5answers
26k views

What is meant by the “native ISO” when talking about DSLRs?

The new Nikon D7000 is out, and a lot of previews has touted the "native iso" of D7000 to be 100. What does this actually mean? I'm assuming it means it performs at its best at iso 100, which means ...
32
votes
4answers
5k views

Why can't the ISO level on most digital cameras be set below 80?

Why is it that the ISO level on most digital cameras doesn't seem to go lower than ISO 80? I understand (vaguely) that the sensors adjust the gain in order to achieve the equivalent of a high ISO ...
12
votes
7answers
2k views

Can someone give a simple explanation of ISO?

Can someone please explain to me what ISO means in the camera settings? In an answer to a question about taking pictures at a dance party, I was told to use ISO 1600. What does that number really ...
11
votes
6answers
12k views

What camera settings would make shooting easy in a darkish church?

I tried to take photographs in a church that was bright enough for human eyes, but I quickly realized the camera couldn't take it. Failing to anticipate this, I didn't bring a tripod. Since I don't ...
7
votes
5answers
17k views

What's the difference between exposure and shutter speed?

Is there a difference between exposure and shutter speed, or are the terms interchangeable? I read that "If you use a quick shutter speed, you can just raise the exposure to compensate." Is this ...
11
votes
4answers
7k views

What is the relationship between ISO, aperture, and shutter speed?

I know digital cameras have ISO options, and that ISO is the camera's sensitivity to light, but if you set higher ISO then you can get a noisy image. I also know there are two other camera options, ...
27
votes
5answers
2k views

Is there any noise difference between averaged and long exposure photos?

Let's suppose I'm on a tripod, photographing a perfectly still scene (also dark) and I take these photos: 5 photos at ISO 3200 and 1s exposure 1 photo at ISO 100 and 5s exposure There is a common ...
12
votes
3answers
6k views

How can I reduce noise at ISO 100 in photos taken in the twilight?

I shoot with a Canon EOS Rebel T5 and sometimes see noise even when shooting at ISO 100. Is this just because there is not enough light in the dark portions of the picture (seen below)? Is this a ...
20
votes
4answers
14k views

What exactly is “base ISO” and how do I find what is base ISO on my camera?

If I understood correctly, base ISO is in full stop steps from the lowest possible ISO setting on my camera. For example if the lowest setting on my camera is ISO 100, than the following table would ...
14
votes
2answers
557 views

Why is the amount of photos that fit on one card dependent on ISO?

I have a Canon 550D with a 16GB SD card. I noticed that, when in P-mode, if I choose an ISO of 100 I can shoot 595 raw files on an empty card. If I choose an ISO of 200 this is 590. And if I choose ...
19
votes
4answers
2k views

What is ISO and how does it affect my photos

What is the ISO setting on my camera? What does it represent? What should I be aware of with regards to ISO when taking photographs
5
votes
4answers
13k views

How can I improve my exposure in low-light situations?

I am new to photography and have been struggling with low light scenarios. I have a Nikon D3100 and an SB-900 flash. Regardless of my ISO, aperture, or shutter speed settings, when I am ...
7
votes
3answers
2k views

Qualitywise, is there any downside to overexposing an image (within the dynamic range of the camera)?

If i underexpose an image and have to crank up the exposure in post, this will also amplify the noise, resulting in a lower quality image. In this case, it would've been better to expose correctly ...
4
votes
4answers
1k views

Is higher ISO noise evenly distributed, or does it affect colors differently?

It's obvious that higher ISO affects the photograph by adding noise or grains. But will that grain or noise be distributed equally over all parts of the photograph, or will it specifically affect ...
5
votes
4answers
10k views

What ISO should I use on my Nikon D5200 to avoid visible noise in 4×6 prints?

I recently bought a Nikon D5200. For several of the photos taken the ISO setting I have used has been high — in the range of 1000 to 4000 (most of them were in poor light, without flash and in manual ...
3
votes
3answers
645 views

Why is my camera metering indoor scenes as darker than I expect, forcing me to use a high ISO?

I am shooting in natural light, with my subject facing a full floor-to-ceiling south facing window. You would think my meter would allow ISO between 200-400 in bright light, but I was lucky to get it ...
3
votes
4answers
2k views

How critical is it to expose raw images correctly?

I have been thinking about the Zone System and its goal of maximising image quality given the limitations of film sensitivity and the necessity to choose specific developing parameters. Clearly you ...
4
votes
3answers
2k views

How can I take non-blurry extreme sports photos in winter?

I currently have a Canon T3 with the basic EF-S 18-55mm f/3.5-5.6 lens that it came with. I'd like to go out to the local ski hill though, and there is a terrain park there. Most of my photographic ...
3
votes
3answers
696 views

ISO when shooting at night

Why does the signal to noise ratio decrease when using high ISO speeds (e.g 3200) when shooting at night with a digital camera?
2
votes
5answers
2k views

What do the scene modes actually do?

I have a Nikon D3300. It has a full-auto mode, various degrees of semi-auto, and a full-manual mode. It also has a box of what you might call "application-specific" modes, for example "landscape", "...
4
votes
1answer
1k views

Why does my Finepix S2950 not show the image quality I expect?

I am a little confused as to why my Finepix S2950 takes photos like it does. I seem to be able to take great Macro Shots, but not landscapes. I have noticed that if I zoom into a picture enough I can ...
0
votes
3answers
691 views

Why are my product photographs not sharp?

I just bought a Canon 750D. The picture has too much noise. The detail/shine of the diamond is not really showing. I am also using a tripod and timer. The lens is the EF-S 18-55mm ƒ/3.5-5.6 IS STM. ...

15 30 50 per page