Linked Questions

12
votes
4answers
8k views

What is the relationship between ISO, aperture, and shutter speed?

I know digital cameras have ISO options, and that ISO is the camera's sensitivity to light, but if you set higher ISO then you can get a noisy image. I also know there are two other camera options, ...
28
votes
5answers
2k views

Is there any noise difference between averaged and long exposure photos?

Let's suppose I'm on a tripod, photographing a perfectly still scene (also dark) and I take these photos: 5 photos at ISO 3200 and 1s exposure 1 photo at ISO 100 and 5s exposure There is a common ...
12
votes
3answers
6k views

How can I reduce noise at ISO 100 in photos taken in the twilight?

I shoot with a Canon EOS Rebel T5 and sometimes see noise even when shooting at ISO 100. Is this just because there is not enough light in the dark portions of the picture (seen below)? Is this a ...
22
votes
4answers
18k views

What exactly is "base ISO" and how do I find what is base ISO on my camera?

If I understood correctly, base ISO is in full stop steps from the lowest possible ISO setting on my camera. For example if the lowest setting on my camera is ISO 100, than the following table would ...
20
votes
4answers
2k views

What is ISO and how does it affect my photos

What is the ISO setting on my camera? What does it represent? What should I be aware of with regards to ISO when taking photographs
14
votes
2answers
566 views

Why is the amount of photos that fit on one card dependent on ISO?

I have a Canon 550D with a 16GB SD card. I noticed that, when in P-mode, if I choose an ISO of 100 I can shoot 595 raw files on an empty card. If I choose an ISO of 200 this is 590. And if I choose ...
8
votes
3answers
2k views

Qualitywise, is there any downside to overexposing an image (within the dynamic range of the camera)?

If i underexpose an image and have to crank up the exposure in post, this will also amplify the noise, resulting in a lower quality image. In this case, it would've been better to expose correctly ...
5
votes
4answers
13k views

How can I improve my exposure in low-light situations?

I am new to photography and have been struggling with low light scenarios. I have a Nikon D3100 and an SB-900 flash. Regardless of my ISO, aperture, or shutter speed settings, when I am ...
4
votes
4answers
1k views

Is higher ISO noise evenly distributed, or does it affect colors differently?

It's obvious that higher ISO affects the photograph by adding noise or grains. But will that grain or noise be distributed equally over all parts of the photograph, or will it specifically affect ...
5
votes
4answers
10k views

What ISO should I use on my Nikon D5200 to avoid visible noise in 4×6 prints?

I recently bought a Nikon D5200. For several of the photos taken the ISO setting I have used has been high — in the range of 1000 to 4000 (most of them were in poor light, without flash and in manual ...
3
votes
3answers
738 views

Why is my camera metering indoor scenes as darker than I expect, forcing me to use a high ISO?

I am shooting in natural light, with my subject facing a full floor-to-ceiling south facing window. You would think my meter would allow ISO between 200-400 in bright light, but I was lucky to get it ...
3
votes
4answers
2k views

How critical is it to expose raw images correctly?

I have been thinking about the Zone System and its goal of maximising image quality given the limitations of film sensitivity and the necessity to choose specific developing parameters. Clearly you ...
4
votes
3answers
2k views

How can I take non-blurry extreme sports photos in winter?

I currently have a Canon T3 with the basic EF-S 18-55mm f/3.5-5.6 lens that it came with. I'd like to go out to the local ski hill though, and there is a terrain park there. Most of my photographic ...
3
votes
3answers
703 views

ISO when shooting at night

Why does the signal to noise ratio decrease when using high ISO speeds (e.g 3200) when shooting at night with a digital camera?
7
votes
2answers
1k views

Is analog gain really actually power-of-two only?

Context I'm using a Nikon D5200, which features extra ISO values between powers of two, that the Nikon D60 did not offer. D60 offers 100, 200, 400, 800, 1600 (1-stop interval). D5200 offers two ...

15 30 50 per page