I recently acquired this tripod and was wondering what this screw is and what I need to do to make this tripod usable with a DSLR.

The screw seems to be a bit wider than half an inch.

What kind of adapter might I need to fit a common tripod head?

Said Tripod

  • possible duplicate of Is there a standard tripod mount? – mattdm May 26 '15 at 17:01
  • Covered by the earlier question — this isn't the standard thread for attaching a camera to a tripod, but is typical for attaching tripod legs to heads. – mattdm May 26 '15 at 17:02
  • Stating the make and model of the tripod will make your question more specific and may shed some more light as to what type of heads are available. – A K May 26 '15 at 17:13
  • Unfortunately I don't know the make of the tripod , it doesn't seem to be anywhere on the body. – y4ku May 26 '15 at 18:02
  • I might also be misunderstanding how to measure the bolt. The width of the bolt is 1/2" but does that translate in some way to a 3/8" "thread"? – y4ku May 26 '15 at 18:07

Basically they sell you either a incomplete tripod or you just need to buy a tripod head:

https://www.google.com.mx/search?q=tripod+head

There are several options to choose from and some brands sell the tripods and heads as separate parts.

  • 1
    Yes. That threaded piece is where the head assembly attaches. The head assembly holds the camera. – A K May 26 '15 at 17:09
  • I have a tripod head but this screw is too large for it. I believe that in general tripod heads require a 1/4" screw and this one is much bigger than that. Slightly over 1/2" wide. – y4ku May 26 '15 at 18:03
  • 4
    Have you tried unscrewing it? There is a slim chance it is an adapter and there is a smaller screw underneath. – Jason Sweeters May 26 '15 at 18:15
  • @y4ku Are you sure it isn't 3/8"-16? Again, see this earlier answer. – mattdm May 26 '15 at 18:46
  • I've tried unscrewing it and can't seem to get it off. The earlier answer doesn't quite answer my question with any certainty, it is a description of two standards that exist. I'm going to pick up a 3/8" to 1/4" converter to see if this is the case. Until then, this is still a mystery. – y4ku May 26 '15 at 19:34

Your Answer

By clicking "Post Your Answer", you acknowledge that you have read our updated terms of service, privacy policy and cookie policy, and that your continued use of the website is subject to these policies.

Not the answer you're looking for? Browse other questions tagged or ask your own question.