0

I can't get the yn560-tx to control my new yn660 light.

The flash fires on test. So it is working.

If I push "act" I can test fire the flash from the transmitter, so they do connect, but I can't pair them for controlling flash from transmitter.

I have figured out how to change hz/fn to match and group/channel. They are synced up.

How do I get the transmitter to control the flash.

I really appreciate any input, I can't figure it out.

  • Additional - I am in "M TX" mode. I discovered that in "multi TX" mode I can control the flash from the transmitter, but it's highest power setting is only 1/4. So again I see that the transmitter and flash are working together, just not how I want them to. – Pol Nov 26 '18 at 22:44
1

Okay, for anyone else who is confused by this - after extensively messing around with settings it turns out that the flash should be in "RX" mode not "TX". I had the impression from the instructons that it was "TX", but apparently I picked it up wrong. It works just fine like that.

I hope this helps anyone else who got that wrong. I tried practically every setting on both transmitter and flash before finding this.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.