22
\$\begingroup\$

Why does a camera's maximum (allowed) aperture get smaller when you increase its zoom?

\$\endgroup\$
1

2 Answers 2

24
\$\begingroup\$

The short answer is because it is cheaper to manufacture such lenses. The longer the lens and the wider the aperture, the larger the optical elements in the lens - thus larger the expense to produce them.

A lens like 70-200/2.8 must have a front optical element of 200mm/2.8=72mm, which is quite a chunk of glass. On the other hand, the 70-300/4-5.6 needs to be 300mm/5.6=54mm wide. If it were f/4 through its full range, the optical element would need to be 75mm wide - even larger than the much more expensive 70-200/2.8.

In your question, you say "the camera's maximum aperture". The camera does not have an aperture - the lens does. Minor but important difference, especially for SLRs - once you remove the lens you see that the camera is just a light bucket with a big hole in the front.

DETAILS:

The aperture is the ratio of the focal length of the lens to the size of the front optical element. Essentially

aperture = focal length / optical element size

For example, a 50mm f/1.8 lens has a 28 mm (50/1.8) element size.

If you're wondering why the f-stop numbers don't seem to be linear (they're not), it is because the amount of light collected by the lens is proportional to the focal length divided by the aperture squared. Because of this power of 2, f/4 collects twice as much light as f/5.6, since 5.6/4=sqrt(2).

\$\endgroup\$
2
  • 2
    \$\begingroup\$ The aperture of a lens isn't the same as the size of its front element, it's the (maximum) size of the internal diaphragm. For example, the Sigma 50/1.4 has a front element much larger (about 70mm) than its internal diaphragm (35.7mm) to minimize vignetting at large apertures. \$\endgroup\$
    – Tzarium
    Jul 11, 2011 at 10:44
  • 10
    \$\begingroup\$ It's not the size of the diaphragm either, but the diameter of the entrance pupil, i.e. the image of the aperture as seen from the front of the lens. On many normal-to-tele lenses, this is not far from the size of the front element, but retrofocus wide-angles have front elements far larger than their entrance pupil. \$\endgroup\$ Jul 11, 2011 at 12:51
2
\$\begingroup\$

F-number is the ratio of aperture opening and the focal length. Imagine an aperture which is fixed in its diameter and located just behind the front element of the zoom lens. regardless of the actual focal length of choice. In this case, as you zoom in (increase FL), the ratio is getting smaller (the F-number is getting bigger). As you zoom-out, the ratio increases (the F-number is getting smaller).

In fixed-aperture lenses, the optical/mechanical design is such that the ratio is maintained throughout the zoom range. This allows zooming in and out while composing w/o worrying the you stopped down the aperture while out, when you need max aperture when you're back in.

\$\endgroup\$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.