Incense

by Bart Arondson

submit your photo


Hall of Fame
View past winners from this year

Please participate in Meta
and help us grow.

Take the 2-minute tour ×
Photography Stack Exchange is a question and answer site for professional, enthusiast and amateur photographers. It's 100% free, no registration required.

I'm winding some film using a daylight bulk winder.

I can't see the point of cutting a leader on the film. My cameras seem to load the film fine without a leader. No leader also gives more film for a film picker to grip, so it is easier to pull out the leader after automated rewind.

So what is the purpose of a leader? Were there some cameras which needed them?

share|improve this question

3 Answers 3

up vote 11 down vote accepted

Indeed, some cameras do need the leader. Usually they are manually loaded and winded - they use take-up spools with a slot for the leader. Advancing the film is performed by turning the take-up spool, and sprockets alone would not provide grip secure enough. For example, Bronica 135N/135W, Nikkormat EL-W.

When the film has been fully rewound into cassette, retrieving its full-width end would be tricky as you'd have to perfectly align the end inside the cassette to the opening; retrieval of a narrow leader makes this awkward task much easier.

The leader (albeit in a much longer form than on most currently produced films) is also useful for correctly loading film into a bottom-loaded camera (such as LTM Leica, FED, Zenit-1 etc) so you wouldn't have to align the film cassette, take-up spool and bare film all at the same time, which would be quite clumsy and prone to fail.

share|improve this answer
2  
This is a good point about actually being EASIER to pull the film out of a cassette when there is a leader. Although there is more film for the film picker to grip without a leader, you have to align the film perfectly. This may explain the problems I was having with a film picker sometimes. –  BBDave Mar 27 '13 at 22:19

From memory, the takeup spool in my Nikon FM had a notch that didn't go the width of the film, so yes you had to have the leader cut to be able to insert it.

As long as you have the film lined up properly, it would seem easier to insert a smaller width of leader into a spool than get the whole width in anyway.

The reverse is true when developing. I always cut off the leader - otherwise it tended to cause the film to start unwinding from the developer tank spool.

share|improve this answer

I think the trick is less wasted film. If you think about the design of most leaders, the leader from one cut of film is also the leader for the next. Since in many (most?) cases, the leader is going to be exposed to light, it is going to be wasted film anyway. By reducing the amount of waste, costs of making the same number of useable frames is reduced.

share|improve this answer
    
But it only saves the film manufacturer film, not the user, right? –  BBDave Mar 27 '13 at 22:20
2  
@BBDave - The manufacturer doesn't just magically absorb the waste cost. Less wasted material at manufacture = cheaper price possible for consumer, at least in theory. –  AJ Henderson Mar 27 '13 at 23:31

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.