Why is the shutter speed so long when using Flash in Aperture Priority on a Nikon D40X?

Question

I'm trying to get the background out of focus (bokeh) and using Aperature(A) mode and setting aperture to lowest value.

Update: I'm shooting in dim light and the flash goes off but the shutter speed incredibly slow (1-2 seconds), even slower than if I put it in full auto (where, presumably, the Aperture would be no wider than in Aperture mode with maximum Aperture .

I did find something in my Nikon Df0/D40X Digital Field Guid (by Busch) that said that in Aperture priority, the shutter speed is limited to 1/60s up to Syc speed. So I assume that means no slower than 1/60s

Here are the photos:

Aperture Priority with Flash (2s Shutter time)

• Exposure : 2s
• F/5.6
• Focal Length: 120mm
• ISO: 100

Full Auto

• Exposure : 1/60 s

• F/5.6

• Focal Length: 135mm (Ok, that's a little different)

• ISO: 200

Answer 1

This is called Slow Sync, which is a technique that allows you to combine flash with an ambient light exposure.

You probably turned this on by mistake. Generally, that's by holding the flash button (the one that pops up the flash) and turning the control wheel.

Your manual is here, see page 47 (in the PDF, technically pg 35 in the actual manual).

Answer 2

Yes, you can you the flash in that configuration. It's possible one of a few things may be going on:

1. If the flash is set to auto, and the camera meters the scene such that it determines that it doesn't need it, it won't use it.

2. The flash option isn't turned on. There should be a menu option to turn your flash on, off, auto, or possibly rear-curtain sync.

3. Your flash has taken a fatal blow and died.

4. Your ISO is high enough that even at a relatively slow maximum aperture, possibility #1 is happening.

You certainly can use flash with A mode though.

Answer 3

If it is the pop-up flash that you are talking about, it does not open up automatically as in the 'Auto' mode. You have to press the flash button (right below the flash on my D60) to manually pop it open. Once it is open, it fires when you click a picture.

Answer 4

If it makes you feel any better, my 7D with a 430EX acts the same way. I think in Aperture mode it considers it fill flash and does not factor it into the shutter speed.

I found the best way to use flash is in M mode. Set your desired aperture and whatever shutter speed you need to freeze the action as you like. As long as your camera/flash has some form of TTL the flash should adjust it's power to light the scene appropriately.

Answer 5

"the shutter speed is limited to 1/60s up to Sync speed. So I assume that means no slower than 1/60s"

No, this means that flash can't sync with the fully open shutter at speeds faster than the quoted value. You can easily sync at slower speeds, so 1/60, 1/30, 1/15, etc are all well sync'd.